WD105 Wi-Fi Kit (Series 5 & 6)
These are the specifications for the WD105 wireless kit. It includes an Intel AC9260 module with Wi-Fi and Bluetooth support, as well as mounting cables and other wires. It runs on all Series 5 players (except the AU5) and on the HD6 and XD6.
The BrightSignOS version should be 9.0.15 or higher.
BrightSign's procurement and integration team can handle WD105 Wi-Fi installation as part of your system setup or service engagement. To request this service, contact [email protected] or your BrightSign sales representative or account manager.
Specs
Wi-Fi
- 2x2 802.11ac protocols: A, B, G, N, AC
- Frequency bands: 2.4GHz, 5GHz
- Tx power:
- 2.4 GHz band: 18 dBm at 20 MHz channel width; 16 dBm at 40 MHz channel width
- 5 GHz band: 15 dBm at 20 MHz channel width; 13 dBm at 40 MHz channel width; 10 dBm at 80 MHz channel width; 8 dBm at 160 MHz channel width
- Security: 128-bit AES-CCMP, 128-bit and 256-bit AES-GCMP
Bluetooth
- Bluetooth 5.1
Installation
Tools
The following tools are required for installation:
- Phillips screwdriver with a PH2/PZ2 tip (PH2 is the US standard, PZ2 is the international standard)
- Phillips screwdriver with a PH1/PZ1 tip (PH2 is the US standard, PZ2 is the international standard)
- 8-inch (200mm) length tweezer with a serrated tip (or precision mini needle-nose pliers)
Notes
BrightSign antennae will fit either SMA connector on the WD105, but the Bluetooth antenna must connect to the pin defined in your process for Bluetooth functionality. The Wi-Fi antenna can work from either connector (but optimal performance requires the designated connector).
This table shows where the connectors should be attached (the Bluetooth wire leads on the LS5 and XC5 differ from other models):
Player Model | Bluetooth Connector | Wi-Fi Connector |
|---|---|---|
XC5 | Closest to audio jack | Furthest from audio jack |
LS5 | Closest to LED lights | Furthest from LED lights |
HD5, XT5, XD5, HD6, XD6 | Furthest from LED lights | Closest to LED lights |
Guides
Download installation guides for your model: